_ptb2007008 6.400E+004 L0 = length of fault trace whose offset rate gets unit weight (in m)2 1.460E+009 A0 = area of continuum whose stiffness & isotropy get unit weight (in m**2) 20 refinements (for nonlinearity) allowed in this solution (try 20-40) 3.700E-016 mu_ = scalar measure of typical anelastic strain rates in continuum (/s) 3.000E-017 xi_ = small strain-rate increment, in /s (Not TOO small! Try 3.2E-17 /s.) 20. sigma, in degrees, of angle between [heave vectors of dip-slip faults] & [trace-normal direction] 6371. radius of planet, in kilometers 1. 11. minimum and maximum locking depths of intraplate faults, in km 14. 40. minimum and maximum locking depths of subduction zones, in km FALSE switch: Do active faults give sigma_1h direction data? ..\common\f_ptb_1.nki filename of fault offset-rates (or, 'none') ..\common\f_ptb_1.dig filename of digitized fault traces (or, 'none') ..\common\s_ptb.nki filename of horizontal principal stress directions (or, 'none') ..\common\ptb11.gps filename of geodetic velocity data (or, 'none') none filename of covariance matrix for geodetic velocity components (or, 'none') TRUE switch: Is velocity reference frame allowed to free-float? FALSE conservative_geodetic_adjustment? (uses geologic slip rates; not self-consistent) ..\common\PTB3nbd.feg filename of finite element grid (required) ..\common\b_PTB3nbd.nki filename of boundary conditions for finite element grid (required) EU plate defining velocity reference frame for type-4 boundary conditions FALSE dump_all_solutions? Creates velocity log file for studying convergence.